Supports both Client and Server implementations. All Modbus serial ports are individually configurable, providing a choice of Modbus RTU or Modbus ASCII support. The PROFIBUS DPV1 Client protocol supports complete Client specifications according to IEC 61158 Version 1 on either a single or multiple Master network. The gateway offers both cyclic and acyclic data transfers from PROFIBUS DPV1 servers, as well as cyclic data transfers from DPV0 servers.
Allows movement of data between dissimilar networks using two communication protocols on one gateway; Protocols share access to a common memory database to exchange data between networks; View diagnostic data for both networks from a single configuration/debug port; Modbus slave protocol interface; Emulate Modbus slave device on each individually-configurable application port;
Floating point data movement supported, including support for Enron, Daniel®, and other implementations; Suitable for SCADA and field device interface applications; PROFIBUS DPV1 Master protocol interface; Supports cyclic communications in V0 and both cyclic and acyclic communications in V1
Power Supply 24 VDC nominal 18 to 32 VDC allowed Positive, Negative, GND Terminals 2.5 mm screwdriver blade; Current Load 500 mA max @ 32 VDC max; Operating Temp -4° F to 122° F (-20° C to 50° C); Storage Temp -40° F to 185° F (-40° C to 85° C); LED Indicators; Configuration Serial Port DB-9M RS-232 only; No hardware handshaking;Ethernet Port (Ethernet modules only) 10Base-T half duplex RJ45 Connector; Link and Activity LED indicators; Electrical Isolation 1500 V RMS at 50 Hz to 60 Hz for 60 s, applied as specified in section 5.3.2 of IEC 60950: 1991 Ethernet Broadcast Storm Resiliency = less than or equal to 5000 [ARP] frames-per-second and less than or equal to 5 minutes duration; Application Ports Modbus Plus Connector Two DB9 Female Standard Modbus Plus connectors; Serial Port Isolation 2500 V RMS port signal isolation per UL 1577 3000 VDC min. port to ground and port to logic power isolation